new CMU-SP1200 COMBO
Features:
- The metal case; Li>
- LED and audible status indication; li>
- AVR stabilizer; li>
- Short-circuit protection; li>
- The overload protection; li>
- Protection against full battery discharge; li>
- Protection of telephone and Internet lines; li>
- voltage filter; li>
- Starting the UPS during a power failure; li>
- Removable power cable is 1.2m.
Vertriebspartner
|
|
Technology
UPS Type |
Off-Line |
execution
Form Factor |
Tower |
Input parameters
Power |
1200 VA |
Input voltage |
220/230 / 240V |
Input voltage range |
140 - 290 V |
Current frequency |
50/60 Hz ± 1% (auto sensing) |
Output parameters
Output voltage |
220 / 230V ± 10% |
Form voltage |
Stepped approximation to a sinewave |
Current frequency |
50/60 Hz ± 1% |
switching time |
2-4 ms, including the determination of the time |
Automatic voltage regulation (AVR) |
1 step down, two steps up |
Protection and UPS equipment
Surge Protection |
Yes |
UPS protection against overloads |
Load ? 120% of the sound signal;† |
120%, the output power is automatically turned off, the speaker begins to beep continuously | |
Protection for UPS input |
Fuse for overload protection and short circuit protection |
UPS protection for short circuit |
Immediate shutdown of the UPS using the input fuse |
Protect the phone, fax, modem, LAN |
1 x RJ45 and 1 x RJ11 |
Ports and interfaces
USB-port |
no |
SNMP-card |
no |
Battery
A type |
Lead acid, sealed, maintenance-free |
Voltage and battery capacity |
12V9AH x 2 |
Typical recharge time |
4 hours (up to full capacity of the battery) |
Connecting additional battery |
no |
Cold start |
Yes |
battery protection |
Automatic verification of the battery and when the protection of the critical category |
Physical parameters
Output connectors |
2 x 2 x Euro and IEC-320 C13 with redundant power and filtration |
UPS Dimensions (W * D * B) mm |
102x340x155 |
Packing dimensions (W * D * B) mm |
137x445x190 |
Weight, kg |
5 |
Gross Weight, kg |
6 |
Indication |
LED (green LED - supply from the mains power, yellow LED - work redime of battery, red LED - overload or fault) |
Sound alarm |
Standby mode - a rare acoustic signal (1 every 5 seconds, then repeat every 60 seconds);†low battery level - sound beeps (last 16 seconds);†overload - a very special sound signal (every 2 seconds); |
Case features
material |
Metal (0.5 mm) |
Electrical connection to the front
Power cable |
Metal (0.5 mm) |
Environmental Parameters
Acoustic noise |
Removable c EURO plug (length 1.2 m) |
Working conditions |
<40 dB (1 meter from the surface) |